This 24v Silicone heater is a great addition to your 3D printer to help in keeping your prints stuck to the build platform.
PRODUCT ALERT (1)
This silicone heater requires at least 15 amps at 24v. To power a printer and the silicone heater you will need at least a 15amp (360W)power supply.
Works with: LulzBot TAZ 6, LulzBot TAZ 5, LulzBot TAZ 4, LulzBot TAZ 3
We suggest a 300mm x 300mm Borosilicate glass plate on top of the heatbed.
This heatbed uses the 100k Honeywell Axial Thermistor. If using Marlin/Sprinter firmware, select temperature table #7 for the correct temperature reading.
298mm x 298mm silicone heater
100k Honeywell Thermistor (embedded)
Maximum Operating Temperature: 120°C (248°F)
Required power supply: 24V
Typical power draw: 8A - 10A
Heater leads terminated with:
Thermistor leads terminated with:
If you are not purchasing this to upgrade a TAZ 3D printer you will need to purchase the matching connectors:
This Heat Bed Kit is a direct replacement for our LulzBot Mini heated bed. Designed for 3D printers powered by 24v power supplies, this heated bed heats rapidly and consistently...
This stepper motor damper reduces the volume of the music your 3D printer makes down to a soft whisper. Works with: LulzBot Mini Features Install this stepper motor damper in between theLulzBot Mini Y-axis...
This thermistor is a direct replacement for the thermistor used in the LulzBot Hexagon Hot End. Use this thermistor for applications at or below a temperature of 300℃. PRODUCT ALERT (1) Installation Warning Failure...
These self-lubricating high-precision bearings run whisper quiet and are used on the LulzBot TAZ 6 3D printer. Little-to-no maintenance is required other than wiping the smooth rods occasionally. Works with: LulzBot TAZ 6...