This 24vDC Switching Power Supply is more than capable of powering RepRap electronics, motors and a heated bed and is the same power supply used in our LulzBot TAZ 3.
PRODUCT ALERT (1)
These power supplies can be switched between 110VAC and 220VAC. If you are in North America make sure to set the switch on the side of the power supply to 110VAC. In most other regions of the world 220VAC should be used. You can find more information here.
Works with: LulzBot TAZ 3
This power supply does not include any wires. You will need to purchase a heavy gauge grounded AC plug with cord.
1 power supply
3 positive terminals, 3 ground terminals, 1 set of AC terminals
110v or 220v AC capable
This Heat Bed Kit is a direct replacement for our LulzBot Mini heated bed. Designed for 3D printers powered by 24v power supplies, this heated bed heats rapidly and consistently...
This stepper motor damper reduces the volume of the music your 3D printer makes down to a soft whisper. Works with: LulzBot Mini Features Install this stepper motor damper in between theLulzBot Mini Y-axis...
This thermistor is a direct replacement for the thermistor used in the LulzBot Hexagon Hot End. Use this thermistor for applications at or below a temperature of 300℃. PRODUCT ALERT (1) Installation Warning Failure...
These self-lubricating high-precision bearings run whisper quiet and are used on the LulzBot TAZ 6 3D printer. Little-to-no maintenance is required other than wiping the smooth rods occasionally. Works with: LulzBot TAZ 6...