Redesigned to be stronger and more reliable, this Beefy Idler Assembly is a direct replacement for the extruder idler used on the LulzBot TAZ 6 and the LulzBot Mini 3D printer, and is compatible with previous LulzBot 3D printer models.
Works with: LulzBot Mini, LulzBot TAZ 6, LulzBot TAZ 5, LulzBot TAZ 4, LulzBot TAZ 3, LulzBot TAZ 2 or 1
Featuring a stronger filament guide, stronger bearing braces, and thicker hinges, this redesigned extruder idler is used to evenly apply pressure to the filament, pressing it against the hobbed bolt used to drive filament into the hot end.
Upgrading is easy-- Unscrew the one M3 screw with a 2.5 mm hex driver. Remove the existing idler, remove the M3 nut, transfer it to the new Beefy Idler, and replace with the Beefy Idler. Screw the M3 screw back in and you are good to go!
1 (one) assembled Beefy Idler
1 (one) 6082RS sealed bearing
1 (one) 8 mm thick stainless steel rod
1 (one) 3D printed Beefy Extruder Idler
The 100k Epcos Thermistor can be used for temperature control for the PCB heated bed or any other temperature controls you may need. If using Sprinter firmware, select temperature table...
This stepper motor damper reduces the volume of the music your 3D printer makes down to a soft whisper. Works with: LulzBot Mini Features Install this stepper motor damper in between theLulzBot Mini Y-axis...
This Heat Bed Kit is a direct replacement for our LulzBot Mini heated bed. Designed for 3D printers powered by 24v power supplies, this heated bed heats rapidly and consistently...
The Pololu A4988 stepper motor driver is the new more robust design to the A4983 driver. The A4988 can be used with any pololu stepper driven Reprap electronics including all...