Minimize warping caused by drafts or cold 3D printing environments with the LulzBot Mini Enclosure by Printed Solid. This enclosure helps keep curious hands and paws away from heated and moving parts of your 3D printer. This acrylic enclosure kit can be assembled without gluing, drilling, cutting, or engraving. Separate tools and 3D printed parts are required, see more information below.
Works with: LulzBot Mini
No gluing, drilling, cutting, or engraving is required for assembly.
The enclosure has a modular design, meaning pieces are easily removable for access and/or printing with large spools of filament.
The enclosure is made with optically clear, lightweight 3mm thick extruded acrylic.
The extruded acrylic can be solvent welded, so pieces can be repaired if broken.
There is a built-in location to mount a 40mm fan to vent air from the enclosure.
Upgradable using your current printer, 3D print four brackets to complete the kit.
When assembled, the enclosure sits on the same table surface as your 3D printer.
Small footprint, adding only 105mm (4.1in) in the Y-axis (from front to back).
Laser cut, extruded 3mm thick acrylic sheets
36 M3-10mm bolts
8 M3-40mm bolts
36 M3 square nuts
2 M3 washers
Printed copy of Assembly Instructions (online here)
Two (2) 3D printed Mini left bracket (STL) (not included, print yourself)
Two (2) 3D printed Mini right bracket (STL) (not included, print yourself)
2mm hex driver
2.5mm hex driver
Optional: Painters tape
Optional: Flat razor
1-2 hours, based on skill level
LulzBot Mini Dimensions (Standard): 435mm x 340mm x 385mm (17.1in x 13.4in x 15.2in)
LulzBot Mini Dimensions (with Enclosure): 435mm x 445mm x 385mm (17.1in x 17.5in x 15.2in)
Enclosure adds an additional 105mm (4.1in) in the Y-axis (from front to back).
Acrylic can easily crack - do not over tighten the screws. Tighten to hold without movement. If a panel cracks, contact Printed Solid directly for replacements at a discount rate.
When cleaning, use dish soap or hand wash and a soft, clean cloth. Do not use Windex® or other glass cleaning solutions. Do not use a hard sponge, scrub, or abrasive surface.
Windex is a registered trademark of S.C. Johnson, Inc.
Have questions? Need replacements? Contact Printed Solid directly by emailing firstname.lastname@example.org or by calling +1-302-439-0098.
This Heat Bed Kit is a direct replacement for our LulzBot Mini heated bed. Designed for 3D printers powered by 24v power supplies, this heated bed heats rapidly and consistently...
This stepper motor damper reduces the volume of the music your 3D printer makes down to a soft whisper. Works with: LulzBot Mini Features Install this stepper motor damper in between theLulzBot Mini Y-axis...
This thermistor is a direct replacement for the thermistor used in the LulzBot Hexagon Hot End. Use this thermistor for applications at or below a temperature of 300℃. PRODUCT ALERT (1) Installation Warning Failure...
These self-lubricating high-precision bearings run whisper quiet and are used on the LulzBot TAZ 6 3D printer. Little-to-no maintenance is required other than wiping the smooth rods occasionally. Works with: LulzBot TAZ 6...