The 100k Epcos Thermistor can be used for temperature control for the PCB heated bed or any other temperature controls you may need. If using Sprinter firmware, select temperature table #6 for the correct temperature reading. This thermistor is used on the LulzBot® Hexagon Hot End but is NOT a direct replacement.
1 Glass thermistor These NEMA 17 stepper motors were custom made for the LulzBot store and Aleph Objects, Inc. internal printers. These stepper motors have been designed to use with RepRap 3D printer builds or any other project needing precise and repeatable movement.
Works with: LulzBot Mini, LulzBot TAZ 5, LulzBot TAZ 4, LulzBot TAZ 3, LulzBot TAZ 2 or 1, LulzBot AO-101 or AO-100
Five motors are needed for a Prusa Mendel, AO-101 and TAZ: one for X axis, one for Y axis, two for Z axis and one for the extruder.
1 Stepper motor with unterminated wires
Step angle: 1.8°
Holding torque: 55 N.cm
Rated voltage: 2.8V
Resistance per phase: 2.8,±10%
Inductance per phase: 4.8,±20%
Operation temp range: -20°C ~ +50°C
4 AWG22 lead wires (ends are bare and need connectors)
5mm D-shaped motor shaft
This Heat Bed Kit is a direct replacement for our LulzBot Mini heated bed. Designed for 3D printers powered by 24v power supplies, this heated bed heats rapidly and consistently...
This stepper motor damper reduces the volume of the music your 3D printer makes down to a soft whisper. Works with: LulzBot Mini Features Install this stepper motor damper in between theLulzBot Mini Y-axis...
The Pololu A4988 stepper motor driver is the new more robust design to the A4983 driver. The A4988 can be used with any pololu stepper driven Reprap electronics including all...
The 100k Epcos Thermistor can be used for temperature control for the PCB heated bed or any other temperature controls you may need. If using Sprinter firmware, select temperature table...